AT&T E2728B - Manual (Page 33)

29
Answering System Operation
Day and time announcements
To set day and time
Before playing each message, the answering system
announces the day and time the message was received.
Before using the answering system, you should follow
the steps on the left to set the day and time, so mes-
sages are dated correctly.
The system uses voice prompts to guide you. Each
time you press
CHANGE
, the day, hour, minute or year
advances by one. When you hear the correct setting,
press
TIME/SET
to move to the next setting.
To check day and time
You can press
TIME/SET
at any time to hear the
current day and time without changing it.
NOTE: Press and hold
CHANGE
to advance the minute or year by incre-
ments of 10 (the year can be set from 2000 to 2039).
NOTE: Caller ID provides the time and date. Set the year so that the day
of the week can be calculated from the Caller ID information. After you set
the time once, it will thereafter be set automatically with incoming Caller ID infor-
mation. The time will be set automatically only if you subscribe to Caller ID service
provided by your local telephone company (see page 5).
1.
Press TIME/SET
The system will announce the cur-
rent clock setting, then announces
“ To begin setting the clock, press
TIME/SET then press CHANGE
to change the setting or press TIME/
SET to continue.”
2. Press TIME/SET
3. Press CHANGE
4. Press CHANGE
until the system announces the correct
hour, then press TIME/SET.
until the system announces the correct
day, then press TIME/SET.
Press CHANGE
until the system announces the
correct minute, then press TIME/
SET
.
5.
6. Press CHANGE
until the system announces the correct
year, then press TIME/SET. The
system announces the current
clock setting.
1 4