Panasonic DMC-FZ200K - Manual (Page 96)

- 96 -
Recording
∫ Changing position and size of the AF area (Only when [Ø] is selected)
If you performing any of the following operations, the screen will switch to the settings menu.
•
When [Ø] is selected, press [FOCUS].
• From the menu screen, select [Ø], and press 1 .
1 Press 3/4/2/1 to move the AF area.
• You can set to arbitrary position of the screen. (It cannot be set to
edge of the screen)
• After moving the AF area, press [DISP.] to return it to the center.
2 Rotate the rear dial to change the size of AF area.
Rear dial right: Enlarge
Rear dial left: Shrink
•
It can be changed to 4 different sizes.
3 Press [MENU/SET] to set.
Note
• AF area cannot be moved during motion picture recording.
• The spot metering target can also be moved to match the AF area when using [Ù].
• Position of the AF area will return to initial state when the camera is set to Intelligent Auto Mode,
when the Sleep Mode is activated, or when this unit is turned off.
• The AF area may not be displayed as intended at certain zoom magnifications or under low light.