Power Soak MX-220-HTS Owner's/Service Manual - Manual (Page 22)

21
Authorized Service Agency Section
Hazard to untrained or unauthorized personnel.
The following procedures are provided for use only by an
authorized service agency. No facility owner, manager, employee
or other unauthorized person should attempt to perform any of these
procedures. To obtain the name of a recommended service agent in
your area, please call the Metcraft, Inc. Power Soak Service
Department at 800-444-9624.
When performing troubleshooting procedures, the authorized
service agency will need to open the Power Soak system's main
electrical enclosure.
Properly close the control panel before reconnecting the circuits.
Refer to the previous checklist under the "Facility Owner / Manager
Section" before proceeding to the following checklist items:
Pump does not work - Heater does not work/exist
Look For Correction
1 No water in sink Fill sink with water
2 LIQUID LEVEL SENSOR dirty Clean LIQUID LEVEL SENSOR
3 No incoming power to unit Reset customer’s breaker in breaker control panel
4 Blown fuses Replace blown fuse – Refer to wiring diagram for correct fuses
5 Loose wires Tighten wires
6 LIQUID LEVEL CONTROL setting is too low See page 23
7 Defective LIQUID LEVEL CONTROL or SOCKET Check and replace as necessary