Vaddio ProductionVIEW HD-SDI - Manual (Page 12)

ProductionVIEW HD-SDI
PIP Display (continued)
To display the PIP, press either of the PIP
buttons, and the PIP will appear on the screen.
Input 3 will now be displayed in a window in the
lower left corner of the screen.
Changing PIP Size: To change the size of the
PIP (small, medium or large), press and hold
the PIP Positioning button and ProductionVIEW
HD-SDI will toggle through the sizes.
PIP In Dual Mode: If ProductionVIEW HD-SDI is set up for Dual Mode (independently switched live feeds
on Preview and Program buses), select the background source. Next, select the PIP source, which will
flash. Press the PIP button for that specific bus, and the window will be displayed. Press the PIP button
to remove the window from the screen. PIP is discrete for the Program and Preview buses when the
system is in Dual Mode.
Master Power, Manual and Auto Modes
If ProductionVIEW HD-SDI is to be used with
an operator at the console, the Manual mode
button will need to be illuminated.
Pressing the Auto button will activate the Auto
mode, which is a configuration when
ProductionVIEW HD-SDI is used in conjunction
with Vaddio’s StepVIEW mats, MicVIEW
system and AutoVIEW IR sensors or other
trigger devices. These triggers allow
ProductionVIEW HD-SDI to automatically
switch between camera inputs and preset
camera positions. In this mode, no operator is
required.
The mats and sensors can be placed in locations, such as podiums, white boards, etc. to allow the
system to be run in “Presenter” or Auto mode. No operator needs to be present when the system is set
up in Auto mode. Camera switching and PTZ movements are handled by ProductionVIEW automatically.
Master Power Switch
• When the Master Power Switch is powered down, all of the attached cameras will be placed in
standby. Press and hold the power switch for 3 seconds to initiate power down sequence. This is
a safeguard to prevent accidental shutdown.
• When the Master Power Switch is powered up, all attached cameras will activate and select
default camera and preset information as defined in the menu. The ProductionVIEW HD-SDI will
scan the inputs for camera type and video signal type and auto-configure accordingly. This can
take up to one minute and is normal operation.
• Note: When the camera control ports are changed or reconfigured, the “Rescan Cameras” option
in the menu must be selected and started to rescan the cameras and reload the proper control
codes
. If only the video inputs are changed, then activate the Rescan Video function in the Main
Menu to reset the video input priorities.
ProductionVIEW HD-SDI Manual 341-852 Rev. B Page 12 of 22