Hawk Industries Hawkjaw Jr. Manual 65K-ALS Serial Numbers 4 to 9 - Manual (Page 12)

Air Requirements
1. Clean, dry air at 100 psi @ a negligible volume.
2. On board auto-dump air filter (AF) (part# 061-A22), located on board the rear of the Hawkjaw.
3. Auto-dump air filter* (Part # 061-J29), must be installed in-line between the air source and the
HawkJaw. Initial filter supplied with the HawkJaw.
4. Enough slack in the line for the HawkJaw to move from its rest position to the drill pipe con-
nection to the mouse hole connection.
12 Installation
WARNING
The HawkJaw must receive clean, dry air.
Running the HawkJaw without a Hawk
approved air filter (Part # 061-J29 & 061-
A22 ) voids the warranty and shortens
component life.
*NOTE
Make sure the air filter (part # 061-J29) is
mounted vertically with the red and black
arrows on the cannister pointing up.
AF