Hawk Industries Hawkjaw Jr. Manual 65K-ALS Serial Numbers 4 to 9 - Manual (Page 51)

Changing the Spinner Chain (cont.)
Maintenance
&
Repair
CP CLP DS
RS
8. From the front of the unit, use the
Needle-nose pliers to remove the
Cotter pins (CP) in one of the
Chain links.
9. Use the hammer to remove the
Chain link pin (CLP).
10. Pull out the old chain. Make sure
the chain does not catch on the
Drive sprocket (DS).
11. Feed the chain into the spinner
behind the Drive Sprocket (DS)
until both ends of the new chain
meet at the roller sprockets (DRS).
12. Feed the ends of the chain around
the outside of the Drive roller
sprockets (DRS).
13. Place the ends of the new chain
together.
14. Insert the Master Link.
15. Place the End Cap on the Master
Link.
16. Use the Needle-nose pliers to
insert the Master Link Cotter
Pins.
Maintenance & Repair 51
Part Numbers
Part Name Part #
Chain 031-24CHAIN
Chain Repair Kit 031-24CHAIN-RK
WARNING
Running a new chain with worn Drive Rollers severely
shortens chain life. If the Drive Roller Groove is no
longer visible, replace the Drive Roller.
H