Hawk Industries Hawkjaw Jr. Manual 65K-ALS Serial Numbers 4 to 9 - Manual (Page 29)

Position for Break Out
Operation
29 Operation
1. Stab the drill stand.
2. Center the Suspension Ring (SR) on the
Lateral tilt screw (LTS).
3. If the HawkJaw rests on the rig floor, use
Raise (R) to raise the HawkJaw 1'- 2' ft.
off the rig floor.
4. If the HawkJaw is hooked back to the
derrick, unhook the HawkJaw.
5. Use the Control Handles (CH) to pull the
HawkJaw onto the drill pipe connection.
6. Use Raise (R) and Lower (L) to center the
Middle wrench dies (MD) and the Bottom
wrench dies (BD) between the shoulder
(S).
7. Keep the Bottom wrench dies (BD) away
from the Hard banding (HB).
8. Keep the Middle wrench dies (MD) and
the Bottom wrench dies (BD) away from
the shoulder (S).
Continued on next page.
LTS
R L
CH
MD
BD HB
S
SR