Hawk Industries Hawkjaw Jr. Manual 65K-ALS Serial Numbers 4 to 9 - Manual (Page 20)

1. Stab the drill stand.
2. Center the Suspension Ring (SR) on the
Lateral tilt screw (LTS).
3. If the HawkJaw rests on the rig floor, use
Raise (R) to raise the HawkJaw 1'- 2' ft.
off the rig floor.
4. If the HawkJaw is hooked back to the
derrick, unhook the HawkJaw.
5. Use the Control Handles (CH) to pull the
HawkJaw onto the drill pipe connection.
6. Use Raise (R) and Lower (L) to center the
Top wrench dies (TD) and the Middle
wrench dies (MD) between the shoulder
(S).
7. Keep the Middle wrench dies (MD) away
from the Hard banding (HB).
8. Keep the Top wrench dies (TD) and the
Middle wrench dies (MD) away from the
shoulder (S).
Operation
Continued on next page.
LTS
R L
CH
TD
MD HB
S
20 Operation
Position for Make Up
SR