NOVUS N1500FT Indicator User Manual
N1500ft indicator
Advertising
Table of contents
Document Outline
- N1500FT Indicator
- FLOW RATE INDICATOR – INSTRUCTIONS MANUAL – V1.2x
- SAFETY ALERTS
- INTRODUCTION
- INPUTS
- RETRANSMISSION
- Flow rate retransmission can be done via 4-20 mA output and pulse output.
- The 4-20 mA output may be used regardless of the type of flow input. To use it, just set the retransmission range to RTLL and RTKL, associating the flow rates to 4-20 mA.
- In the case of retransmission via pulse output, one must choose between volumetric pulse output and frequency pulse output. The former may be used regardless of the type of input, while the latter is available only for pulse inputs.
- In the volumetric mode, a pulse of configurable length is generated every time the totalizer accumulates a preset volume. For example, for a period of 1 second and volume of 10 liters, a 1-second pulse will be generated for every 10 liters totalized. ...
- Note: In case the feeding process is running and the totalizer is reset by the user, the process will remain running normally, but the output pulse will not be synchronized with this process anymore, which can lead to a missing pulse informed at the e...
- In the frequency mode, the pulse output will divide the input frequency by a programmable constant whose value is equal to or higher than 2.
- IMPORTANT: Maximum output frequency has hardware limitation. See Specifications. Check the “Specifications”.
- Alarms
- SPECIAL FUNCTIONS
- INSTALLATION
- Fig. 10 – Pulse output connection
- Fig. 11 - 24 V auxiliary power supply connection
- operation
- PROGRAMMING THE INDICATOR
- CONFIGURATION PROTECTION
- MAINTENANCE
- CALIBRATION
- SERIAL COMMUNICATION
- SPECIFICATIONS
- WARRANTY