Goulds Pumps 3171 - IOM - Manual (Page 9)

Wash the skin and eyes
Do the following if chemicals or hazardous fluids have come into contact with your eyes or your skin:
If you need to wash your... Then...
Eyes
1. Hold your eyelids apart forcibly with your fingers.
2. Rinse the eyes with eyewash or running water for at least 15 minutes.
3. Seek medical attention.
Skin 1. Remove contaminated clothing.
2. Wash the skin with soap and water for at least one minute.
3. Seek medical attention, if required.
Safety regulations for Ex-approved products in potentially explosive
atmospheres
Description of ATEX
The ATEX directives are a specification enforced in Europe for electrical and non-electrical equipment.
ATEX deals with the control of potentially explosive atmospheres and the standards of equipment and
protective systems used within these atmospheres. The relevance of the ATEX requirements is not limited
to Europe. You can apply these guidelines to equipment installed in any potentially explosive atmosphere.
General guidelines
ATEX compliance is only fulfilled when the pump is operated within its intended use, for example within
its intended hydraulic range. The conditions of the service must not be changed without approval of an
authorized ITT representative. When installing or maintaining ATEX-compliant pumps, follow these
guidelines:
• Always install ATEX-approved equipment in compliance with the directive and applicable standards
(IEC/EN 60079–14).
• Do not install FM-approved products in locations that are classified as hazardous in the national
electric code, ANSI/NFPA 70–2005.
WARNING:
Installation, Operation, and Maintenance manuals clearly identify accepted methods for disassembling
units. These methods must be adhered to. Trapped liquid can rapidly expand and result in a violent
explosion and injury. Never apply heat to impellers, propellers, or their retaining devices to aid in their removal.
If there are any questions regarding these requirements, the intended use, or if the equipment requires
modification, contact an ITT representative before you proceed.
Personnel requirements
ITT disclaims all responsibility for work done by untrained and unauthorized personnel.
These are the personnel requirements for Ex-approved products in potentially explosive atmospheres:
• All work on the product must be carried out by certified electricians and ITT-authorized mechanics.
Special rules apply to installations in explosive atmospheres.
• All users must know about the risks of electric current and the chemical and physical characteristics of
the gas and/or vapor present in hazardous areas.
• The maintenance operation for Ex-approved products must be made in conformity to the
international or national standards (IEC/EN 60079-17).
Product and product handling requirements
These are the product and product handling requirements for Ex-approved products in potentially
explosive atmospheres:
• Only use the product in accordance with the approved motor data stated on the nameplates.
• The Ex-approved product must never run dry during normal operation. Dry running during service
and inspection is only permitted outside the classified area.
Introduction and Safety (Continued)
Model 3171 Installation, Operation, and Maintenance Manual 7