Pump priming – Goulds Pumps HT 3196 i-FRAME - IOM User Manual
Page 56
Pump priming
Prime the pump with the suction supply above the pump
1. Slowly open the suction isolation valve.
2. Open the air vents on the suction and discharge piping until the pumped fluid flows out.
3. Close the air vents.
1
2
3
1.
Discharge isolation valve
2.
Check valve
3.
Suction isolation valve
Prime the pump with the suction supply below the pump
Use a foot valve and an outside source of liquid in order to prime the pump. The liquid can come from
one of these sources:
• A priming pump
• A pressurized discharge line
• Another outside supply
1. Close the discharge isolation valve.
2. Open the air vent valves in the casing.
3. Open the valve in the outside supply line until only liquid escapes from the vent valves.
4. Close the vent valves.
5. Close the outside supply line.
Commissioning, Startup, Operation, and Shutdown
54
Model HT 3196 i-FRAME Installation, Operation, and Maintenance Manual