Goulds Pumps HT 3196 i-FRAME - IOM - Manual (Page 97)

122
168A
253B
382
136
112A
9. Install the bearing housing as follows (see the illustration):
a) Coat the outside of the outboard bearing (112A) with oil.
b) Coat the bore of the bearing housing (134) with oil.
c) Put the bearing housing (134) onto the shaft.
Do not use force.
122
253B
134
112A
168A
10. Prepare the shaft for assembly as follows (see the illustration):
a) Place the bearing-clamp ring (253B) onto the shaft (122).
b) Fasten the clamp-ring bolts (236A) crosswise.
See the specified torque values.
Make sure that the shaft rotates freely.
c) Install a new O-ring (496).
d) Install the outboard labyrinth oil-seal (332A) into the bearing housing (134).
Place the drain slots of the oil seal at the bottom position (6 o’clock).
Make sure that the edges of the keyway are free from burrs. To protect the O-ring, cover the
keyway lengthwise with a piece of electrical tape before you install the oil seal.
236A
253B
134
332A
496
11. Install the shaft assembly into the bearing frame as follows (see the illustration):
Maintenance
Model HT 3196 i-FRAME Installation, Operation, and Maintenance Manual 95