Goulds Pumps HT 3196 i-FRAME - IOM - Manual (Page 82)

134
122
112A
11. Remove the bearing locknut (136), the bearing lockwasher (382), and the outboard bearing (112A).
NOTICE: Use force only on the inner race when you press bearings off the shaft. Do not use force
in situations in which you might break a part. Doing so may result in equipment damage.
NOTICE:
Save the bearings for inspection. Do not reuse the bearings. Doing so may result in decreased
performance.
122
136
112A
382
Disassemble the power end ( XLT-i and i17 with duplex bearings)
1. Remove the bearing frame to frame foot (241) using the frame-foot bolts (370F).
228A
241
370F
370D
423
134
370C
2. Remove the clamp screws (370C) and back off the jam nuts (423).
3. Tighten the jack screws (370D) evenly to move the bearing housing (134) out of the bearing frame
(228A).
4. Remove the shaft assembly from the bearing frame (228A).
5. Remove the jack screws (370D) and the nuts (423).
6. Remove the bearing housing O-ring (496) and the inboard bearing (168A).
Maintenance
80 Model HT 3196 i-FRAME Installation, Operation, and Maintenance Manual