Goulds Pumps ICB - IOM - Manual (Page 33)

Installation, Operation and Maintenance Instruction Model ICB
ICB 100-English page 24 Revision 00
Article No 21999991 Issue 05/2006
Design: S1...2 Single mech. seal, unbalanced (DIN 24960, l
1k
/ EN 12756, design K, form U), Impeller with
back vanes
You find the shaft sealing of your pump on the data sheet / the order confirmation. Refer to chapter 3.1.1, Design
coding system, as well.
125-100-200 125-100-250 150-125-250 200-150-250
80-50-315 100-65-160 100-65-200 100-65-250 125-80-160 125-80-200 125-80-250
65-40-160 65-40-200 65-40-250 65-40-315 80-50-160 80-50-200 80-50-250
40-25-160 40-25-200 40-25-250 50-32-160 50-32-200 50-32-250 50-32-315
Valid for
Part name: V
o
lut
e
casin
g
Casing cover Support foot Pump alignment Stub shaft Impeller Motor lanterne Gasket O-ring Mech. seal W
ear ring
F
ixing ring
W
a
sher
Bevelwasher Bevelcup W
a
sher
G
uard plate
F
lange motor
Hexa
g
onal screw
Hex
a
g
onal screw
Hex
a
g
onal screw
Hex
a
g
onal screw
Stud Grub screw Grub screw Grub screw Grub screw Drain
p
lu
g
Hexa
g
onal nut
Impeller nut Key
No. 102 V 161 183 ***) 183P **) 210 230 341 400 412.21 433 502.11 *) 527 **) 554.41 554.42 ***) 554.43 ***) 554.44 ***) 681 801 901.11 901.31 **) 901.42 901.43 ***) 902.41 904.11 *) 904.31 **) 904.41 904.42 912.11 920.41 922 940.31 *) ... optional **) ... not for all designs ***) ... with IEC-Motor sizes: 160MA, 160M, 160L, 180M, 180L, 200L, 200LA, only
Subject to techn. alterations!
Not to scale!