Goulds Pumps ICB - IOM - Manual (Page 35)

Installation, Operation and Maintenance Instruction Model ICB
ICB 100-English page 26 Revision 00
Article No 21999991 Issue 05/2006
Design: S4...2 Single mech. seal, unbalanced (DIN 24960, l
1k
/ EN 12756, design K, form U), with quench,
Impeller with back vanes
For shaft sealing of your pump refer to data sheet / order confirmation. See chapter 3.1.1, Design coding system,
as well.
125-100-200 125-100-250 150-125-250 200-150-250
80-50-315 100-65-160 100-65-200 100-65-250 125-80-160 125-80-200 125-80-250
65-40-160 65-40-200 65-40-250 65-40-315 80-50-160 80-50-200 80-50-250
40-25-160 40-25-200 40-25-250 50-32-160 50-32-200 50-32-250 50-32-315
Valid for type:
Part name Volute casing Casing cover Support foot Pump alignment Stub shaft Impeller Motor lantern Gasket O-ring O-ring Mech.
seal
Q
uench cover
W
ear ring
F
ixing ring
T
h
rottle bush
W
a
sher
Bevelwasher Bevelcup W
a
sher
G
uard plate
F
lange motor
Hexagonal screw Hexagonal screw Hexagonal screw Hexagonal screw Stud Stud G
rub screw
G
rub screw
G
rub screw
G
rub screw
Drain plug Hexagonal nut Hexagonal nut Impeller nut Key
No. 102 V 161 183 ***) 183P **) 210 230 341 400 412.21 412.32 433 471Q 502.11 *) 527 **) 542.31 554.41 554.42 ***) 554.43 ***) 554.44 ***) 681 801 901.11 901.31 **) 901.42 901.43 ***) 902.31 902.41 904.11 *) 904.31 **) 904.41 904.42 912.11 920.31 920.41 922 940.31 *) ... optional **) ... not for all designs ***) ... only with IEC-Motor sizes: 160MA, 160M, 160L, 180M, 180L, 200L, 200LA
Subject to techn. alteration!
Not to scale!