AMT Datasouth 400 - Manual (Page 29)

User's Guide 29
8. Continue to click the Display Up/Down buttons as needed until the feature to be modified
is displayed on the top line of the display. (ex. Baud Rate)
Figure 18 – Changing Features
9. Click the Enter button to enter the Change mode. The top line of the display should start
blinking to indicate the Change mode is active.
10. Click the Display Up/Down buttons as needed to select the new value.
11. Click the Enter button to save the new value and exit the Change mode. The top line of
the display should no longer be blinking.
Figure 19 – Changing Feature Values
12. When all features have been adjusted, click the Online/Offline button and the printer is
now ready for use. If a PAL program is loaded, the message now displayed on the
simulated printer LCD will vary depending on the program.
Setup Feature and Value List