AMT Datasouth 400 - Manual (Page 74)

User's Guide 74
Appendix E: HIDDEN SETUP FEATURES
To access the hidden list of features, select the Firmware Rev. feature then click the Enter button twice. The hidden
feature list is now enabled and may be selected by clicking the Display Down button.
Hidden Setup Feature and Value List
FEATURE NAME VALUE RANGE DESCRIPTION
Ripple Pattern N/A Click the Enter button to
initiate a rolling ASCII ripple
pattern.
Factory Defaults N/A Clicking the Enter button
resets all keypad features to
factory defaults. If the RTC
clock is installed, these
features are not reset. The
Label Count Feature can not
be reset. Caution: This
feature could cause a loss of
communication with host if
interface features have been
modified.
PAL Boot Drive [A:,B:,C:, Auto Detect] This feature selects the boot
drive. During power up the
system will scan the boot
drive for a PAL program to
run. If Auto Detect is selected
the system will scan all
drives in succession, starting
with A:, searching for the first
PAL program to run.
F/W Update Mode N/A Clicking the Enter button
causes main firmware control
to be halted and boot load
firmware to be loaded. This
mode has a distinct setup
mode feature list allowing
serial port parameters to be
adjusted for the firmware
download. See Appendix F
on firmware updates for more
information.