RMS Technologies R356-RO CONTROLLER/DRIVER - Manual (Page 19)

Be sure to also ground the USB485 card with Pin 2, ground.
Figure 8: Connection using USB485Converter Card
Changing the Address of the Controller
Use a screwdriver to turn the dial so the arrow points to the desired Address. Use
this number when programming commands. For example, /1P1000R
Figure 9: Address Dial
Note: New RoHS compliant boards have a Black dial instead of a Red one.
Connecting Accessories
If you have purchased the Designer’s Kit, there is a Red Push Button and an Optical
Sensor included. Follow the schematics below in order to properly assemble
accessory pieces.
Push Button
R356 Controller & Driver Page 19 Version 1.01
RMS Technologies 4/3/2009