Festo Пневматические линейные приводы SLG - Manual (Page 23)

SLG−...
Festo SLG−... 0802d English
23
S Fasten the component as in Fig. 9.
Component supported
Points
Minimum distance: every 100 mm Surface
Minimum evenness
УУУУУУУУУ
Fig. 9
If the minimum distances are not observed,
an individual functional check may be necessĆ
ary.
S Place the work load on the slide as folĆ
lows:
ć The tilting torque of force F parallel to
the cylinder axis and distance a should
remain as small as possible.
ć Mass moments of interia occurring in a
dynamic application should be calcuĆ
lated, especially with changing loads.
S Select the screw for fastening the work
load with maximum screwing depth as in
Fig. 11 / Fig. 12.
j 8 12 18
L
6
4 mm 5 mm 8 mm
j
1
M4 M4 M5
Fig. 12
Fig. 10
УУ
УУ
У
У
ОО ОО
Fig. 11