Festo Привод со шпинделем и трапециевидной резьбой DMES - Manual (Page 10)

DG..−...−GA, FDG−...−GA, DMES−...−GA
Festo DG..−...−GA, FDG−...−GA, DMES−...−GA 0503a English
10
2 Method of operation and use
The protected guide of linear axis DG..−/FDG−/DMES−... −GA covers all profile underĆ
cuts of the linear axis guide. It offers a smooth easy−to−clean surface. The cover
profile protects the guide against dirt particles falling down onto the axis.
The protected guide has been designed as a factory−supplied variant element for
linear axes types DGE(L)−...−KF, DGP(L)−..., DGPI(L)−..., FDG−... and DMES−...Ă. It is
not intended for linear axes of type DGE−...−RF.
3 Conditions of use
Please note
S Make sure that the specifications in this chapter are always observed.
The product will then function correctly and reliably.
S Compare the maximum values in these operating instructions with your actual
application (e.g. forces, frequencies, masses, speeds, temperatures).
Only if the loading limits are observed can the device be operated in accordĆ
ance with the relevant safety guidelines.
S Take the ambient conditions at the
location into consideration.
Corrosive environments will impair
the service life of the product.
S Please observe the regulations appliĆ
cable to the place of use and comply
with national and local regulations.
S Use the product in its original state. Unauthorized modification is not
permitted.
Fig. 2
[°C] [%] [mbar]