Festo Кабели и принадлежности User Manual
Spc200 smart positioning controller
Advertising
Table of contents
Document Outline
- Contents
- Designated use
- Target group
- Service
- Important user instructions
- Notes on software version
- Notes on the use of this manual
- List of abbreviations
- System summary
- Fitting
- Installation
- Commissioning
- Contents
- 4.1 Procedure for commissioning
- 4.2 Preparations for commissioning
- 4.3 Commissioning with WinPISA
- 4.3.1 Selecting a specification for the axis
- 4.3.2 Configuration of the axis parameters
- 4.3.3 Configuration of the application parameters
- 4.3.4 Configuration of the settings for analogue reference value specification
- 4.3.5 Loading the axis configuration into the SPC200
- 4.3.6 Functional check of the stepping motor axes
- 4.4 Commissioning with the control panel
- 4.5 Program example
- 4.6 Instructions on operation
- Diagnosis and error treatment
- Technical appendix