Festo Кабели и принадлежности User Manual
Spc200 smart positioning controller
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Contents
- Designated use
- Safety regulations
- Target group
- Service
- Important user instructions
- Product-specific terms and abbreviations
- Documentation for the SPC200 Smart Positioning Controller
- Information on operating system versions of the SPC200 and software versions of WinPISA
- Summary of components
- Fitting
- Installation
- Contents
- 3.1 General instructions on installation
- 3.2 General instructions on fitting the pneumatic components
- 3.2.1 the compressed air supply
- 3.2.2 Service unit
- 3.2.3 Compressed air reservoir (optional)
- 3.2.4 Proportional directional control valve type MPYE-...
- 3.2.5 Compressed air tubing and screw connectors
- 3.2.6 Drives
- 3.2.7 General instructions on measuring systems
- 3.2.8 Requirements of the mechanism
- 3.2.9 Mass load
- 3.3 Additional pneumatic circuits
- 3.4 Dimensional reference system - terms and definitions
- 3.5 Installing the SPC200
- 3.5.1 Selecting the power unit
- 3.5.2 Connections on the supply module
- 3.5.3 Connections of the diagnostic module
- 3.5.4 Connections of the I/O module type SPC200-DIO-...
- 3.5.5 Connections of the analogue input module type SPC200-2AI-U
- 3.5.6 Connections of the sub-controller module type SPC200-SCU-AIF
- 3.6 Installing the modules on the axis interface string
- Commissioning
- Controlling the SPC200
- Operating the SPC200 with the control panel
- Contents
- 6.1 Structure and functions of the control panel
- 6.2 Setting project-specific parameters
- 6.3 Edit program
- 6.4 Edit position register
- 6.5 Controlling the program sequence
- 6.6 Displaying operands and system states
- 6.7 Set controller factors
- 6.8 Test and diagnostic functions of the control panel
- Description of the commands
- Diagnosis and error treatment
- Notes on installing the pneumatic components
- Optimizing the positioning behaviour
- Technical appendix
- Contents
- C.1 Sequence plans for the programmer
- C.2 Cable length and cross-sectional area
- C.3 Internal layout of the inputs/outputs
- C.4 Technical specifications
- C.4.1 Technical specifications for the SPC200
- C.4.2 Technical specifications of axis interface type SPC-AIF-...
- C.4.3 Technical specifications of the I/O function module type SPC-FIO-...
- C.4.4 Technical specifications of control panel type SPC200-MMI-1
- C.4.5 Technical specifications of control panel type SPC200-MMI-1F
- Index