Second nc word – Festo Кабели и принадлежности User Manual
Page 250
6. Operating the SPC200 with the control panel
6−38
Festo P.BE−SPC200−EN en 0901d
First NC word (continued)
NC
command
Description
Supported
operating mode
Start/Stop
Record
Select
#S
Set single−bit operand
√
ć
#R
Reset single−bit operand
√
ć
#T
Test single−bit operand for 1−signal
√
ć
#TN
Test single−bit operand for 0−signal
√
ć
#LR
Load register
√
ć
#AR
Add to register
√
ć
#TR
Test register
√
ć
√ = Command is supported
ć
= Command not supported in this mode
Second NC word
NC
command
Description
Supported
operating mode
Start/Stop
Record
Select
*
Using the last positioning mode (G90, G91)
The last programmed positioning mode (relative or
absolute move) remains effective.
√
√
G90
Absolute dimension specification
(pre−setting at program start)
√
√
G91
Relative dimension specification
√
√
√ = Command is supported