Festo Кабели и принадлежности - Manual (Page 191)

5. Controlling the SPC200
5−5
Festo P.BE−SPC200−EN en 0901d
Switch−on behaviour of the SPC200
1
Depends on fault
(see chapter
Diagnosis)
Fault?
Switch on the power LED
Switch on the error LED
Initialization and self test
(max. 10 s)
No
Yes
Make starting program
available. Error LED goes out
Error LED remains
alight or flashes
Switching on
Controller
enable?
(Enable
= 1?)
No
Ready output is set.
Controller is switched on.
Actual position = nominal
position (closed−loop
controlled stop)
SPC200 is ready for
operation
Yes
1
Fig. 5/1: Switch−on behaviour of the SPC200