Festo Кабели и принадлежности - Manual (Page 221)

6. Operating the SPC200 with the control panel
6−9
Festo P.BE−SPC200−EN en 0901d
The menus on the control panel
Menu Description
SPC200 READY
SYSTEM CONTROL >
System control:
Control functions Start, Stop, Reset
SPC200 READY
DISPLAY >
Displays:
Operands, system states
SPC200 READY
EDIT PROGRAM >
Edit program: 1)
Displaying and processing programs and
position registers, Teaching
SPC200 READY
CONFIG. SYSTEM >
Configure system:
Determine operating mode and starting
programs, display and accept hardware
configuration
SPC200 READY
AXIS PARAM. >
Axis data:
Display and set (e.g. cylinder length)
SPC200 READY
APPLIC. PARAM. >
Application data:
Display and set (e.g. project zero point)
SPC200 READY
CONTROL PARAM.>
Control parameters:
Display and set
SPC200 READY
TEST/DIAG. >
Test and diagnosis:
Program test, movement test, etc.
1) The editing of programs with the MMI is recommended only for
small test programs.
Please note that from operating system version 4.63 onwards
there are new NC commands and expansions that are no
longer supported by the MMI.
Please use WinPISA, version 4.3 or higher.
New feature
as from
OS 4.63