Festo Кабели и принадлежности - Manual (Page 114)

3. Installation
3−36
Festo P.BE−SPC200−EN en 0901d
Please note
If you wish to use a different connecting cable, note the
following pin assignment: Use a screened cable and
connect the screening to the plug housing.
In this way you will avoid faults in data transmission.
1
Pin assignment:
2: Received
Data (RxD)
3: Transmitted
Data (TxD)
5: Signal Ground
(SGND)
1
2
3
5
Fig. 3/11: Pin assignment of the serial interfaces (X4)
Connect the diagnostic cable (programming cable) as follows:
ć 9−pin plug on the 9−pin socket of the diagnostic module
ć 25−pin or 9−pin socket on the serial interface of your PC.
Instructions on connecting control panel type
SPC200−MMI−1F can be found in section 3.6.3.