Festo Кабели и принадлежности - Manual (Page 307)

7. Description of the commands
7−41
Festo P.BE−SPC200−EN en 0901d
G08 Acceleration for approach ramp
ć pneumatic axis; ć permitted in operating mode: Start/Stop, Record Select
Nn G08 X<Acceleration> [Y.., Z.., U..]
<Accelera-
tion>
n Acceleration in %−steps of the configured maximum
acceleration; 0 = 100 %, 1 = 1 % ... 99 = 99 % n = 0 ... 99
Rn
1) Acceleration in %−steps of the configured maximum
acceleration saved in register Rn;
0 = 100 %, 1 = 1 % ... 99 = 99 % n = 0 ... 99
@n
1) Absolute value of the acceleration in [m/s 2 ] or [10 3 °/s 2 ]
saved in position register @n; permitted:
0.01
Ţ @n Ţ defined maximum acceleration
n = 0 ... 99
Effect With the following commands positioning is carried out at maximum with the
acceleration specified here:
Ĉ G01 and G02
Example N020 G08 X50 Y50
N021 G01 X80 FX50
N022 G08 X0
;Approach ramp = 50 %
;Move to position X80
;Approach ramp with maximum acceleration
The X−axis is accelerated when approaching position X80 by only 50 % of the
configured maximum acceleration. The acceleration for the X−axis is then switched
to maximum acceleration.
Remark This command has a saving effect. It remains effective until a new approach ramp is
defined.
1) This syntax is only available as from operating system version 4.6. Programs which contain this
syntax cannot be edited with control panel type SPC200−MMI−1... .