Festo Кабели и принадлежности - Manual (Page 217)

6. Operating the SPC200 with the control panel
6−5
Festo P.BE−SPC200−EN en 0901d
Button Description
Esc Ĉ Switches back to the next−higher menu level
Ĉ Rejects the current entry (entry aborted)
Ĉ Deletes the current NC record if the cursor in the
Editor is positioned at the code identifier for NC
record number (N).
Enter Ĉ Confirms the current menu selection
Ĉ Transfers the setting or operating function underĆ
taken into the SPC200
Ĉ Inserts a copy of the current NC record if the cursor
in the Editor is positioned at the code identifier for
NC record number (N).
{ } Ĉ Select next menu command or parameter
Ĉ Position the cursor to the left/right
vV Modify the setting at the current cursor position
Ĉ Increase/reduce number value
Ĉ Select axis (set axis identifier code)
Ĉ Select NC command or diagnostic function
Switch−on reaction
When the power supply is applied, the SPC200 automatically
performs an internal test. During the brief test phase, the
control panel shows the software version number of the conĆ
trol panel (here Vn.n).
MMI SPC200 Vn.n
INITIAL TEST
The SPC200 is then ready to process user commands entered
on the control panel. If a fault is ascertained, the control
panel will show the current fault number (see chapter 8.2).
If there is no fault, the basic setting will be shown.