Application data – Festo Кабели и принадлежности User Manual
Page 230
6. Operating the SPC200 with the control panel
6−18
Festo P.BE−SPC200−EN en 0901d
Application data
Menu APPLIC. PARAM
The application data are configuration data which describe
the conditions of use specified by the application.
Application data for pneumatic axes
The application data are an important basis for the internally
ascertained control data.
Please note
Modified application data do not become effective until
after a program reset. If the mounting position is modified
or if the supply pressure is increased/decreased by more
than 1Ăbar, new identification travel (system identification)
may be necessary.
From operating system version 4.82 onwards, a Workpiece
mass in initial state" can be specified independently of the
configured maximum workpiece mass <TOOL LOAD>. This
gives you the capability of adapting to your process the effecĆ
tive mass load when the system is switched on. This new
function is not supported by the MMI. Please use WinPISA,
version 4.41 or higher.
New feature
as from
OS 4.82