System configuration – Festo Кабели и принадлежности User Manual
Page 236
6. Operating the SPC200 with the control panel
6−24
Festo P.BE−SPC200−EN en 0901d
System configuration
Menu CONFIG. SYSTEM
In the menu CONFIG. SYSTEM you can specify the desired
operating mode as well as the starting programs for your
system.
Description of the individual parameters
Menu CONFIG. SYSTEM (Configure system)
ACTUAL CONFIGUR.
1. AIF
Display current configuration
Displays the hardware configuration ascertained during the start−up
phase.
n. AIF
; 1...2 axis interface string (n = 1...2)
n. SM
; 1...3 stepping motor (n = 1...3)
If stepping motor indexer modules are installed, the selection n. SM"
will show which axis identifier of the first, second or third stepping
motor indexer module has been assigned.
The selection n. AIF" shows which axis identifiers have been assigned
during the start−up phase and which modules have been recognized on
the relevant string. The recognized module types (CP modules) are
listed one after the other as follows:
I
= input module
O
= module with outputs or valves
I/O = function I/O module
The entry −" means that an appropriate module has not been
recognized.
Example: 1. AIF AXIS: XY
CP−MOD: −, −, I/O,
Explanation: Two axis interfaces were recognized on the first axis interĆ
face string during the start−up phase. These were assigned with the axis
identifiers X and Y. A function I/O module has also been recognized on
the axis interface string.
SET CONFIGUR.
SAVE CONFIGUR.
Save the actual configuration as the nominal configuration
Note the instructions on how to proceed in chapter 4.3.1.
When the system is started, the SPC200 checks whether the current
hardware configuration is the same as the nominal configuration. The
installed modules as well as the string assignment are checked here.
The current hardware configuration (installed modules) and the current
string assignment can be saved as the nominal configuration with this
command. If the axis configuration has been modified, all data already
entered will become invalid and will be reset to the status as at delivery
or deleted.