Festo Кабели и принадлежности - Manual (Page 74)

2. Fitting
2−18
Festo P.BE−SPC200−EN en 0901d
Fitting the I/O function module
I/O function modules are intended for fitting onto a flat
surface and for hat rails.
Fitting onto a wall For fastening to a flat surface you will require a mounting
area of approx. 70 x 80 mm
2 . The following diagram shows
the dimensions for the four threaded holes of screw size M4.
1
I/O function
module type
SPC−FIO−2E/2A−M8
POWER
DIAG
OUTPUT
PNP
0 1
INPUT/OUTPUT
INPUT 0 1
67 mm
40 mm
1
Fig. 2/10: Fitting dimensions of the I/O function module
Fitting onto a hat rail In order to fit the I/O function module onto a hat rail, you
will require mounting kit CP−TS−HS35. This kit consists of
two fastenings, two M4*12 screws and two washers.
Proceed with fitting as follows:
1. Fit a hat rail (support rail EN 50022 ć 35x15;
width 35Ămm, height 15 mm).
2. Fasten the hat rail at least every 100 mm to the fastening
surface.
3. Snap both fastenings into the hat rail (see Fig. 2/11).
4. Screw the housing to the fastening with the screws and
washers supplied, as shown in the following diagram.