Festo Кабели и принадлежности - Manual (Page 218)

6. Operating the SPC200 with the control panel
6−6
Festo P.BE−SPC200−EN en 0901d
In the basic setting the control panel shows the following
message:
Enter Esc
SPC200 Vnnn X
SELECT WITH <>
1 2
3
1
Operating system version of the SPC200 (nnn = version
number); the dot after the main version identifier is not
shown due to lack of space; nnn corresponds to n.nn
2
Currently configured axes (here X−axis)
3
Reference line: With { } you can select your menu
Fig. 6/2: Basic setting on the control panel
By pressing the Esc button several times you can access the
basic setting. A special procedure is only required for exiting
the Program Editor (see chapter 6.3.1).
In the basic setting the control panel offers eight menus for
selection. The following diagram gives an overview of the
menu structure and menu commands on the control panel: