Festo Кабели и принадлежности - Manual (Page 292)

7. Description of the commands
7−26
Festo P.BE−SPC200−EN en 0901d
Overview of commands
The following characters are used in the overview tables for
explaining the syntax:
Identifier Description
[..] Parameters listed in brackets can be specified as an alternative or
additionally
1)
..|.. Parameters separated by vertical lines can be specified as an
alternative
n Wildcard for numerical values
<WILDCARD> Wildcard e.g. for:
Ĉ operands (e.g. Q0.0)
Ĉ positions
Ĉ speeds
Ĉ acceleration
Ĉ etc.
1) In order to facilitate reading, axis identifiers are shown in simple form ( [Y.., Z.., U..] ).
Additional parameters have been left out intentionally.
The following table contains an overview of the NC comĆ
mands arranged according to theme.