Kramer Electronics VP-4x4K - Manual (Page 22)

18 VP-4x4K - Operating Your Audio Matrix Switcher
The STATUS Display Shows: When:
Initial Display
Unit characteristics:
Firmware version
About 2 seconds (automatically)
after switching on the power
The STATUS shown here is an
example of what could typically be
displayed. The actual display depends
on the current firmware version
Normal Display
Normal display:
Inputs switched to
the outputs
During normal operation, appears a
few seconds after the first display
The STATUS shown here is an
example of what could typically be
displayed. The actual display depends
on the current video and audio
switching status
Audio Gain Display
Audio gain mode After pressing the AUDIO GAIN
button and selecting an output or an
input
The STATUS shown here is an
example of what could typically be
displayed. The actual display depends
on the current audio gain level
In addition, the 7-segment display shows the:
• Switching delay time when setting the delay time (see Section 6.3 )
• Selected machine number when setting the machine number (see Section 6.4 )
6.2 Adjusting the Audio Gain
You can adjust the audio gain for each input (from -100dB to +20dB) and output
signal (from -100dB to +13dB).
To set the audio output gain, do the following:
When using the RC-IR3 remote controller you can only adjust the output volume. To adjust the
volume of an output, press the VOL +/- key (to increase or decrease the volume respectively)
and then the number of that output.
Audio inputs switched
to the outputs
The audio gain level