Kramer Electronics VP-4x4K - Manual (Page 23)

VP-4x4K - Operating Your Audio Matrix Switcher 19
1. Press the AUDIO GAIN button on the front panel.
2. Press a SELECTOR OUT button to select the output for which you want to
increase or decrease the gain.
3. Press the + or – buttons on the front panel to increase or decrease the gain,
respectively.
To set the audio input gain, do the following:
1. Press and hold the SELECTOR IN button for which you want to increase or
decrease the gain.
2. Press the + or – buttons on the front panel to increase or decrease the gain,
respectively.
To exit the audio gain function, press any of the control buttons. If unused, this
command times out after 20 seconds.
You can use the RC-IR3 remote controller to adjust the output
volume. To adjust the volume of an output, press the VOL +/- key
(to increase or decrease the volume respectively) and then the
number of that output
6.3 Setting the Switching Delay Time
You can achieve clean transitions when switching between non-genlocked
sources by setting the delay time—ranging from 0sec to 3.5sec (in increments of
0.5sec) —via the DELAY DIP-switches. The
VP-4x4K is shipped (its factory default
state) with no delay, that is, the DELAY is set to 0sec.
To set the delay time, do the following:
1. Press the STO and LOCK front panel buttons simultaneously to access the
DELAY mode.
The 7-segment display shows the current switching delay time.
2. Use the + and – front panel buttons to set the delay time as required.
i