Kramer Electronics VP-773 - Manual (Page 14)

VP
-7
7
3
–
Ov
e
rv
ie
w
9
Figure 2: VP-773 Presentation Switcher/Scaler Rear Panel
# Feature Function
17 AUDIO IN
Unbalanced
Connectors HDMI 3.5mm Mini Jack Connect to an unbalanced audio source for audio takeover of the HDMI 1 to HDMI 4 embedded audio (see
Section 6.3 ). The pinout is defined in Section 5.4
18 PC 3.5mm Mini Jack Connect to the unbalanced stereo audio of the computer graphics source (from 1 to 2). The pinout is defined
in
Section 5.4
19 DP 3.5mm Mini Jack Connect to the unbalanced stereo audio source for analog audio takeover of the DisplayPort embedded
audio (see
Section 6.3 ). The pinout is defined in Section 5.4
20 CV (L, R) RCA Connect to the unbalanced stereo audio of the composite video source
21 MIC 1 6mm Jack Connect to a microphone (see pinout in Section 5.3 )
22 COND/DYN MIC
DIP-switch Select between a condenser and a dynamic type microphone
23 MIC 2 6mm Jack Connect to a microphone (see pinout in Section 5.3 )
Note that Mic2 on the rear panel is identical to Mic2 on the front panel. Mic2 on the front panel overrides
Mic2 on the rear panel when connected
24 COND/DYN MIC
DIP-switch Select between a condenser and a dynamic type microphone
25 REMOTE IR 3.5mm Mini Jack (opening)
Covered by a cap. The 3.5mm connector at
the end of the internal IR connection cable
fits through this opening
Connects to an external IR receiver unit for controlling the machine via an IR remote controller (instead of
using the front panel IR receiver)
Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the machine (only if
the internal IR connection cable has been installed)
, see Section 8.4.1
26 AUDIO LINE OUT (L, R) Terminal Block
Connector Connect to the L and R balanced stereo audio acceptor
27 S/PDIF OUT RCA Connector Connect to a digital audio acceptor
28 Power Connector with Fuse AC connector, enabling power supply to the unit
29 POWER Switch Switch for turning the unit on or off