Kramer Electronics VP-773 - Manual (Page 41)

36 VP-773 - The OSD Menu
Setting Function
Advanced Set:
V Keystone
– to set the vertical keystone level E
Useful If the projector is located at an angle above or below the screen. In the
OSD menu the value range shows -80 to 80. For interlaced inputs, this feature is
disabled
Auto Sync Off – to turn the auto sync On/Off.
When ON, 2 minutes after not detecting a valid video signal on the selected
input (or both inputs in the dual window mode), the unit will disable the
syncs and the audio on all the outputs, until a valid input is again detected
or any keypad button is pressed to activate the machine (once restored, the
buttons return to their normal function)
E
When using the VP-773 for audio only, we recommend that you
turn this feature off
Luma Keying – to set the transparency level of the PIP window (see
Section 6.8.1 ) E
Alert System – to set the Alert system On or Off (see Section 6.8.2 ) E
Pause Set:
Freeze
– to ON to freeze the window (freezing the main window will also
mute the audio output) M / P
Blank – to ON to display a blank window (blanking the main window will
also mute the audio output) M / P
Note that any change in the input source may cancel the freeze
and blank settings.
Mute – to ON to mute the audio output E
A mute icon appears on screen
Disable Outputs – to turn the sync and audio On/Off.
When ON, the unit will disable the syncs and mute the audio output until
any keypad button is pressed
E
Once Disable Outputs is selected, a countdown appears, letting you cancel the
process and revert to the previous state
Protocol Set the communication protocol to P3K or Legacy (see Section 12 ) E
When setting the Protocol to Legacy, some PC applications (for
example, K-Upload) as well as the Web pages may not function
properly.
Test Pattern Set the Test pattern to Slide Bar (non-HDCP), Color Bar (HDCP) or Off.
Each test pattern includes a sinusoid audio signal at 10dB @1kHz.
We recommend that you set the Display Mode to Single Window (see
Section 6.2 ) and set the Output Resolution to 1080p (see Section 6.7 ).
Note that the Color Bar test pattern changes the OSD menu coloring and
the following message appears on the display: “Ignore OSD Coloring”
Factory Reset Reset to factory default values (see Section 11.1 ) E
Once Factory Reset is selected, a countdown appears, letting you cancel the
process and revert to the previous state
i
i
i