Sunlight Supply Grozone Control SCC1 Temperature, Humidity and CO2 Controller Simple One Series - Manual (Page 10)

10 of 12
Grozone SCC1 Advanced User Guide – March 2012 www.grozonecontrol.com
Step 4 - Understanding the FACTORY / ALTERNATE SETTING EDIT MODE
IMPORTANT: in this mode, the KNOBS and LED INDICATORS take other meanings.

Day Temperature Knob: to select the PARAMETER (among 3).

Temperature Indicators: to indicate the selected PARAMETER.

Pushbutton: to select the right setting (up to 6 settings per PARAMETER)

Day Humidity Knob: to change the setting values.

Humidity and CO2 Indicators (A to F): to indicate the setting values.
CHANGING THE CO2 ELEVATION PARAMETER

Turn the SELECT knob (Day Temperature) to position 1. The top PARAMETER indicator will lit.

CLICK the Pushbutton to select the VALUE Indicator (A to F) you need to turn ON (Lit) or OFF.

Rotate the SET/RESET knob (Humidity Temperature) to turn ON/OFF the selected indicator (selected
indicator is flashing; flashing will stop once value has been set or reset).

To EXIT and SAVE, make sure to move through all 6 indicators. Successful saving will blink the VALUE
indicators 4 times.
Indicator Name Effect Indicator Name
Add 500 ft Add 500 ft to Sea Level if Indicator is Lit Add 4000 ft Add 4000 ft to Sea Level if Indicator is Lit
Add 1000 ft Add 1000 ft to Sea Level if Indicator is Lit Add 8000 ft Add 8000 ft to Sea Level if Indicator is Lit
Add 2000 ft Add 2000 ft to Sea Level if Indicator is Lit
Ex. Elevation has been set to 5000 ft, valid for Denver Colorado area.