Cirrus Logic CS4244 - Manual (Page 31)

DS900F1 31
CS4244
4.6 Internal Signal Path
The CS4244 device includes two paths in which audio data can be routed. The analog input path, shown in
yellow, allows up to four analog signals to be combined into a single TDM stream on the SDOUT1 pin or
output as stereo pairs on the SDOUT1 and SDOUT2 pins. The DAC1-4 path, highlighted in blue, converts
serial audio data to analog audio data.
4.6.1 Routing the Serial Data within the Signal Paths
4.6.1.1 ADC Signal Routing
In TDM mode, the CS4244 is designed to load the first four slots of the TDM stream on the SDOUT1 pin
with the internal ADC data. Additionally, in order to minimize the number of SDOUT lines that must be run
to the system controller in a multiple IC application, the SDOUT data for up to 4 devices can be loaded
into a single TDM stream by side chaining the devices together, as shown in
Figure 20 . To enable the
sidechain feature, the “SDO CHAIN” bit in the "SP Control" register must be set.
I 2 C Control
Data
Control Port
Level Translator
VL
1.8 to 5.0 VDC
RST INT SDOUT1
LDO Analog Supply 2.5 V
VA
5.0 VDC
VD
2. 5 VDC
Serial Audio Interface
SDOUT2 Serial Clock
In/Out
Master Clock In Frame Sync
Clock / LRCK
SDIN1 SDIN2
AIN4 (±)
AIN3 (±)
AIN2 (±)
AIN1 (±)
Digital Filters
Multi-bit
 ADC
AOUT1 (±)
AOUT2 (±)
AOUT3 (±)
AOUT4 (±)
Interpolation
Filter
Multi-bit 
Modulators
Channel Volume ,
Mute, Invert,
Noise Gate
DAC &
Analog
Filters
Master
Volume
Control
Figure 19. Audio Path Routing