Norgren Flow Controls - Manual (Page 29)

Littleton, CO USA Phone 303-794-2611 www.norgren.com FIT-3-29
Function Fittings and Flow Controls
Dimensions in Inches (mm)
mm O.D. tube x ISO G Banjo Bolt
Pressure Sensor Fitting- 102GD
This sensor fitting produces an end of stroke signal when exhaust back pressure in a cylinder
decays below a set value. It should be mounted directly on the cylinder and can be used with a
flow control device mounted into the top port.
It is recommended that the sensor supply pressure to port 1 be the same as the nominal working
pressure of the cylinder.
J 13.220
C
D BSPP
ØG
H
B
D
E
C
I
A
F H
J
B
G
A
1
2
Inch O.D. tube x NPTF Banjo Bolt
Pressure Sensor Fitting- 124GD
This sensor fitting produces an end of stroke signal when exhaust back pressure in a
cylinder decays below a set value. It should be mounted directly on the cylinder and
can be used with a flow control device mounted into the top port.
It is recommended that the sensor supply pressure to port 1 be the same as the
nominal working pressure of the cylinder.
J 13.220
C
D BSPP
ØG
H
B
D
E
C
I
A
F H
J
B
G
A
1
2
A B E
Product Tube NPT NPT J
Number O/D Thread C D Thread F G H I A/F
12 4GD 0218 5/32" 1⁄8
0.35 1.77
1⁄8
0.39 0.39 0.83 1.12
9/16''
(9) (45) (10) (10) (21) (29)
12 4GD 0228 5/32" 1⁄4
0.43 1.85
1⁄4
0.39 0.56 0.83 1.33
3/4''
(11) (47) (10) (14) (21) (34)
A B E
Product Tube ISO G ISO G J
Number O/D Thrd C D thread F G H I A/F
10 2GD 0418 4 1⁄8
0.35 1.77
1⁄8
0.39 0.24 0.83 0.98 0.59
(9) (45) (10) (6) (21) (25) (15)
10 2GD 0428 4 1⁄4
0.43 1.85
1⁄4
0.39 0.28 0.83 1.14 0.75
(11) (47) (10) (7) (21) (29) (19)