Vollrath Mix30 - Manual (Page 11)

English
Operating instructions
11
- Turn off the device by pressing ON/OFF [K1];
TURN THE SOCKET’S MAIN SWITCH TO POSITION "0" AND PULL OUT
THE PLUG;
- Open the plug’s shell and invert TWO of the THREE conductors connected at the
phases (R-S, R-T or S-T);
- Close the plug’s shell, plug in the device and repeat the check.
6 D
EVICE
’
S OPERATION
6.1 Warnings
WHEN USING THE DEVICE, AS WITH ALL ELECTRICAL APPARATUS, ESSENTIAL RULES MUST BE
COMPLIED WITH, PARTICULARLY:
- never touch it if your feet or hands are wet;
- never operate it while barefoot;
- never pull the supply cable to disconnect it from the mains network;
- avoid liquids to penetrate in the device, for example during its cleaning;
- forbid children and unable people to operate it.
In case of failure and/or malfunctioning of the device - and every time you notice damages, mainly at the supply cable or at
the safety devices - switch it off from the main breaker and unplug it. Contact qualified and certified personnel for
assistance.
NEVER operate the machine in DRY conditions or with an amount of mixture other than the one recom-
mended.
The beater is designed to shift liquids, NOT to grind solids.
NOT RESPECTING THESE RULES, IN ADDITION TO VOIDING ANY FORM OF WARRANTY, CAN SERI-
OUSLY COMPROMISE THE SAFETY, PERFORMANCES AND FUNCTIONING OF THE SAME DEVICE.
6.2 Controls and indicators
All controls and indicators for the use of the device are grouped in a single control
panel placed on the frontal panel. Its functioning is electronically managed in low
voltage.
In this manual, the buttons and indicators are identified with the relative symbol, and/or
with an imprint ([K…] for pushbuttons, [Z…] for indicators).
The functioning of every control is described hereby: to obtain the best results, an
acknowledgment is suggested.
ON/OFF Pushbutton [K1]
When the electric supply is connected, the machine is ready to be turned on, the green indicator [Z1] is on. When pressing
[K1], the machine is on, a short electronic test is performed and the other pushbuttons are enabled. The display shows the
temperature inside the tub, in °C.