Vollrath Mix30 - Manual (Page 7)

English
Operating instructions
7
- Remove both the lateral panels unscrewing the relevant fixing screws [21];
- Find and unscrew the bolts [22] which fix the device’s frame at the packing’s basement;
The outlet of the supply cable is placed on the device’s lower side. During the lifting make sure not to
damage it.
- Lift the device from the basement, possibly working on the lower side, near the wheels, and however, only on the
frame’s carrying parts. Remove the basement, and lean the device on the floor avoiding bumps;
DO NOT insert objects, ropes or brackets for the lifting THROUGH the device, since these could damage
the inside parts.
- Re-close the lateral panels;
- Replace or move the packing, which is produced with entirely recyclable materials ( ).
5 I
NSTALLATION
THE INSTALLATION MUST BE CARRIED OUT ONLY BY THE ASSISTANCE SERVICE OR BY TECHNI-
CALLY AUTHORISED PERSONNEL AND IN COMPLIANCE WITH THE LAWS IN FORCE, ALWAYS FOL-
LOWING INSTRUCTIONS OF THE MANUFACTURER.
5.1 Placing and check of the parts
Place the device on the floor, on a flat and steady surface.
Install the device away from any source of heat, avoiding a direct exposition to sun
radiation and making sure that air can freely circulate around each side of the device
itself.
The devices with AIR CONDENSING need at least a 20'' (50cm) free
space in front of the condenser’s grill, to assure the refrigerating plant
correct functioning. Further information are reported on the Technical
Book (Technical Data section).
Check that all of the listed components are present:
- Lid [5];
- Drip tray [26] with bracket [27];
- Tap [11] including: inner body [12]; piston [13]; cover [14], lever [15]; fastening knob [16];
- all the technical documentation (in addition to this handbook): the Technical Handbook, the EC’s Conformity Certifi-
cation and Electrical Test’s Schedule.