Vollrath Mix30 - Manual (Page 14)

English
Mixer
14
- press SET UP [K8] again. On the display “P2” will flash, showing that you can proceed to set up the required tempera-
ture for the Low heating and cooling mixing automatic cycle;
- press SET UP [K8] again. The display shows the Low temperature [Tb]. If required, adjust temperature by pressing
ADJUSTMENT [K2] or [K3]. The manufacturer’s setting is 65°C (149 °F). The adjustment range is +60°C (140 °F)
…+70°C (158 °F);
- press SET UP [K8] again. The display shows the preservation temperature at the end of the automatic Low heating and
cooling mixing cycle [Tcb]. If required, adjust temperature by pressing ADJUSTMENT [K2] or [K3]. The manufacturer’s
setting is +4°C. The adjustment range is +1°C…+6°C;
- when you press SET UP [K8] again (or wait for a few seconds), the settings are stored, the SET UP mode terminates
and the machine is ready to be used.
6.5 Production
In devices with water condensation, check that the condensation water’s faucet is open;
- Before beginning the production, wash, rinse and proceed at the hygienisation with a detergent and disinfecting solution
(see section 7 - WASHING).
Note: If you plan to have more than one consecutive production cycles, you can avoid the washing between a cycle
and the other, making sure you begin with the clearer mixtures.
- check that the START light [Z1] is on. If not, check that the plug has been inserted properly and that the Main switch is
in position "1";
- check that the lid is closed, otherwise the device will not operate;
- press ON/OFF [K1].
- check that the mix extraction tap is well turned off (turned completely towards the right) and transfer the mix into the
tank. MAXIMUM tank capacity is 30 litres, recommended MINIMUN quantities are generally:
- 1/4 of maximum capacity during heating and cooling mixing;
- 1/5 of maximum capacity during preservation.
Too little mixture can cause excessive overheating or the development of ice and cause damage or
irregular squirts and foam during production; too much mixture can slow down or not complete the
process of heating and cooling mixing cycles and cause overspills.
- add ingredients to be heat and cool with the mixture;
- close lid; if you require to pre-blend the ingredients, operate whipper by pressing MANUAL BEATING [K4], when
ready, press it again, to stop whipper;