Replacing the heat sink assembly – Lenovo S310 All-in-One User Manual
Page 107
9. Connect the new microprocessor fan cable to the system board. See “System board parts and
10. Reinstall the system board shield. See “Removing and reinstalling the system board shield” on page 96.
11. Reinstall the computer cover. See “Removing the computer cover” on page 89.
12. Go to “Completing the parts replacement” on page 121.
Replacing the heat sink assembly
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety
information” in the Safety, Warranty, and Setup Guide that came with your computer. To obtain a copy of the
Safety, Warranty, and Setup Guide, go to:
This section provides instructions on how to replace the heat sink assembly.
CAUTION:
The heat sink and fan assembly might be very hot. Turn off the computer and wait three to five
minutes to let the computer cool before removing the computer cover.
To replace the heat sink assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or other flat surface. Hold the sides of your computer and
gently lay it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See “Removing the computer cover” on page 89.
4. Locate the heat sink assembly on the system board. See “FRU locations” on page 80.
5. Remove the system board shield. See “Removing and reinstalling the system board shield” on page 96.
6. Follow the sequence
1
,
2
,
3
,
4
on the heat sink assembly to loose the four screws that secure the
heat sink assembly to the system board.
Note: Carefully loose the four screws from the system board to avoid any possible damage to the
system board. The four screws cannot be removed from the heat sink assembly.
Chapter 8
.
Replacing FRUs
101