Lenovo S310 All-in-One - Manual (Page 66)

Diagnostic Error Code FRU/Action
005-027-XXX Video Configuration/Setup error 1. Run the Setup Utility program.
2. Video drivers update
3. Video card, if installed
4. System board
005-031-XXX Video Device Cable failure 1. Video cable
2. Monitor
3. Video card, if installed
4. System board
005-032-XXX Video Device Controller failure 1. Video card, if installed
2. System board
005-036-XXX Video Register error 1. Video card, if installed
2. System board
005-038-XXX System BIOS extension failure 1. Video card, if installed
2. System board
005-040-XXX Video IRQ failure 1. Video card, if installed
2. System board
005-195-XXX Video Test aborted by user Information only Restart the test, if necessary
005-196-XXX Video test halt, error threshold exceeded 1. Press F3 to review the log file.
2. Restart the test to reset the log file.
005-197-XXX Video test warning 1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 51.
2. Re-run test
3. Replace the component called out in warning
statement.
4. Replace the component under test.
005-198-XXX Video test aborted 1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 “Using
the Setup Utility program” on page 51.
2. Flash the system and re-test. See “Flash update
procedures” on page 127.
3. Go to “Undetermined problems” on page 76.
005-199-XXX Video test failed, cause unknown 1. Go to “Undetermined problems” on page 76.
2. Flash the system and re-test. See “Flash update
procedures” on page 127.
3. Replace component under function test.
005-2XX-XXX 005-3XX-XXX Video subsystem error 1. Video card, if installed
2. System board
006-000-XXX Diskette interface Test Passed No action
006-0XX-XXX Diskette interface error 1. Diskette drive Cable
2. Diskette drive
3. System board
006-195-XXX Diskette interface Test aborted by user Information only Restart the test, if necessary
60 Lenovo S310 All-In-OneHardware Maintenance Manual