Konica Minolta BIZHUB C360 - Manual (Page 152)

bizhub C360/C280/C220 7-15
7.1 [System Settings] 7
[Punch Regist Loop Size Adjustment]
Correct the orientation of the paper and adjust the punched hole position to be parallel with the left edge of
the paper. The angle of the punched hole is corrected by adjusting the resistance applied to the paper for
each paper type.
0 This adjustment is available if the Punch Kit PK-517 is installed.
1
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment]
ö [Finisher Adjustment] ö [Punch Regist Loop Size Adjustment].
2
Select a paper type for which the punched hole angle is adjusted.
3
Press [+] or [-] to adjust the punch position.
4
Press [OK].
5
Create a sample, and check the print result.
[Paper Alignment Plate Settings]
Adjust the width of the paper alignment plate to align the output sheets of paper.
0 This item is available if the Finisher FS-529 is installed.
1
Press Utility/Counterö[Administrator Settings]ö[System Settings]ö[Expert Adjustment]ö[Finisher
Adjustment]ö[Paper Alignment Plate Settings].
2
Select the paper alignment plate position.
3
Press [+] or [-] to adjust the position.
4
Press [OK].
[Color Registration Adjust]
If color shifts are detected in the print result, adjust the each color print position for each paper type.
0 The procedure for adjusting the color registration is the same for yellow, magenta and cyan.
1
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment]
ö [Color Registration Adjust].
2
Select a color to be corrected.
3
Select a paper type for which color registration is adjusted.
4
Load the paper into the Bypass Tray.
% The loadable paper size is 11 e 17 w, 8-1/2 e 11 v, A3 w, or A4 v.
5
Press the Start key.
A test pattern is printed.