Konica Minolta BIZHUB C360 - Manual (Page 69)

bizhub C360/C280/C220 5-12
5.1 [Basic] 5
[Offset] [Yes]/[No] Specify whether to separate each set of copies from another set in the output
tray when copying multiple sets of multi-page originals.
When the Finisher FS-527, Finisher FS-529, or Job Separator JS-505 is not
installed:
If the following conditions are met, printed copies are fed out and sorted in an
alternating crisscross pattern.
•
The 8-1/2e11, A4, or B5 size paper is used
• Paper of the same size and type is loaded with the w orientation in one pa-
per tray and with the v orientation in another tray
• Auto paper selection is specified for the paper size setting
When the Finisher FS-527, Finisher FS-529, or Job Separator JS-505 is in-
stalled:
The copies are fed out and stacked on top of each other with each set shifted
to separate it.
[Fold/Bind] Staples copy outputs in the center the paper or fold them in the center before
discharging.
[Half-Fold] [Center Staple & Fold]
[Staple] Staples copies in corner or at two points before they are output.
[Punch] Punches holes in copies before they are output.
[Position Setting] Configure desired staple or hole-punch positions.
Select Auto, and the machine automatically judges the staple or punch posi-
tions for the paper relative to the original direction loaded.
•
A staple or punch position along the long side of the paper is selected if the
original length is 11-11/16 inches (297 mm) or less.
• A staple or punch position along the short side of the paper is selected if
the original length exceeds 11-11/16 inches (297 mm).
• Staple or punching positions are set on the upper or left-side end.
• Be sure to load the original so that its top side is placed in the back.
• If desired, press [Original Direction], and then select the original direction.
Settings
1 1 1