Konica Minolta BIZHUB C360 - Manual (Page 212)

bizhub C360/C280/C220 9-10
9.2 Troubleshooting table 9
Icons that appear in the touch-panel screen
[The job log has reached the
maximum allowed. Contact the
administrator.] The write area of the job log has
reached the maximum allowed. Obtain the job log using Page-
Scope Web Connection.
[No Animation Guide data avail-
able. Contact your administra-
tor.] Animation guide data is not in-
stalled. For details on installing anima-
tion guide data, contact your
service representative.
[Verify that external keyboard is
properly connected. It may not
be connected or multiple key-
boards may be connected.] The compact keyboard is not
connected to this machine. Turn off the main power of this
machine, connect the compact
keyboard to this machine. Wait
at least 10 seconds, and then
turn on the main power of this
machine.
Message Cause Remedy
Icon Description
Indicates that data is being sent from the machine, regardless of the cur-
rent mode.
Indicates that the machine is receiving data, regardless of the current
mode.
Indicates that an error occurred during an image stabilization operation, a
print operation or a scan operation.
Press this icon to view a screen containing a warning code.
If the warning screen has been closed while a warning occurs, press this
button to display the warning screen again.
Appears when there is a message indicating that consumables must be re-
placed or the machine requires maintenance. Press this icon to display the
message, and then perform the replacement or maintenance procedure.
Appears when an error occurs with the connection to the POP server.
Indicates that there is no paper in the paper tray.
Indicates that very little paper remains in the paper tray.
Appears if the optional Image Controller IC-412 v1.1 is installed. When
this icon is pressed, the Image Controller IC-412 v1.1 setting screen ap-
pears.
Indicates that "Enhanced Security Mode" is set to "ON".
Appears when the external memory (USB memory) is not connected.
Indicates that a nonstandard external memory has been connected to this
machine, therefore, USB connection is not enabled.
Indicates that the job is in the waiting-for-redial status because, for exam-
ple, the recipient's line is busy when sending with the G3 Fax or IP Address
Fax function.