Konica Minolta BIZHUB C360 - Manual (Page 226)

bizhub C360/C280/C220 10-12
10.1 Using an authentication unit (biometric type) 10
14
Click [Finish].
Installation of the Data Administrator Bio Plugin is completed, which completes the setup.
User registration
To register a user with Data Administrator, connect the authentication unit to the USB port of the computer,
and also connect the computer to this machine via network.
1
If the authentication unit is already connected to this machine, turn the Main Power Switch of this ma-
chine off, and then disconnect the authentication unit.
% When the authentication unit is already connected to the computer, go to step 4.
NOTICE
To turn the Main Power Switch off and on, first turn the Main Power Switch off, and then turn it on
after 10 or more seconds has elapsed. Not doing so may result in an operation failure.
When connecting or disconnecting the USB cable, hold the plug. Otherwise, the machine may be dam-
aged or a failure may occur.
2
Turn on the Main Power Switch of this machine.
3
Connect the authentication unit to the USB port of the computer that contains Data Administrator.
NOTICE
Do not connect another USB device to the same port as for the authentication unit. Doing so reduces
the USB power supply, resulting in an operation failure.
To use the USB hub, be sure to connect the self-power USB hub that supplies 500 mA or more.
Restart the procedure 5 or more seconds after connecting the authentication unit.