Konica Minolta BIZHUB C360 - Manual (Page 99)

bizhub C360/C280/C220 5-42
5.4 [Application] 5
5.4.7 [Erase]
[Frame Erase]
Copies can be produced by erasing shadows of punched holes, unnecessary areas around the original text,
such as the transmission information on received faxes and the shadows of punched holes. All four sides
around the original can be erased in the same width or in a different width for each side.
%
Press [Application] ö [Erase] ö [Frame Erase].
[Non-Image Area Erase]
This function enables copying with the ADF open while having an original that cannot be loaded in the ADF
placed at a desired position on the Original Glass.
The original is automatically detected and the area outside the original text is erased.
Erase methods include [Bevel] and [Rectangular]. [Bevel] is used when the background of the original is thin
and [Rectangular] is used when it is dark.
You can place the original on any position without opening or closing the ADF so that you can make copies
promptly. In addition, toner consumption will be reduced as the area outside the original text is erased.
Settings
[Frame] Erases the four sides of the original in the same width.
[Top] [Right] [Bottom] [Left] Erases each frame side in a different width.
[+]/[-] Press [+] or [-] to set the erasing width between 1/16 inch (0.1 mm) and 2
inches (50.0 mm). The erasing width can also be entered using the keypad.
[None] Sets the erasing width to 0 inches (0 mm).
A
A:1/16 inch to 2 inch (0.1 mm to 50.0 mm)
A